Led Light Strip for Flux_Delta 3D printer. It slips on the Camera Pod and uses old cell phone 3.7V Li-ion battery.
Uses 4x 5mm white LEDs connected in parallel and one 15ohm resistor in series with the 3.7V battery. Should last a few days of continuous operation with a single charge.
Not critical, I used 25%
More from 3D Printer Accessories
Save to Dropbox
If you’re logged into Dropbox, you can save directly to Dropbox.
Show Some Love
Say thanks by giving mc_ott a tip and help them continue to share amazing Things with
the Thingiverse community.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.