This is a Microscope mount for an Amscope 150 series microscope. The design should fit any microscope with a 28mm barrel +/- 3mm. It is designed to use the Logitech C270 webcam which you can get pretty much anywhere for 30 bucks. it MIGHT fit any of the older Logitech USB webcames but use at your own risk
a M3 Bolt and Nut are required to tighten it to the tube of the microscope
Arrange the 2 halves of the print so the flat side is against the print bed. After printing attach the ring mount to the microscope and then take the face plate off of your C270 webcam. insert the webcam as shown and then put the two flat sides of the print together until you can get a feel for what alignment will give you optimal viewing.
Next step is to get some superglue and apply a small drop to the bottom half of the camera holder on the flat side. Put the two flat sides together and make sure you move and align the camera before the glue dries. Afterwards it will be perfect and you can use it again and again.
Printed in eSun PLA+ with 36% honeycomb infill.
Printed in eSun PLA+ with 36% infill
Designed with a photograph and Fusion 360