MyGeiger 2 Case
by cain666, published
Liked ByView All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
a simple case for the MyGeiger Geiger counter from www.rhelectronics.com. the photos show my version before i did some changes to the design, the new design should look nicer and the power switch hole was a little misaligned.
you'll need to trim the header for the display down about a mm and you'll need 2 15mm male-female spacers (use nylon as they are close to the HV section on the board)
the hole in the middle of the top radiation symbol is for a LED bezel to extend the count LED to the front panel (bezel is installed in the photos but no LED in the bezel)
the 3 extra holes in the bottom of the lid are for a handle that i havent designed or decided if i want yet..
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingTools and Utilities
Repair, slice, or enhance this Thing
MyGeiger 2 Case by cain666 is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving cain666 a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure cain666 would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).