This thing is remix based on my previous "Eachine TX01 TX02 FPV camera mount with double guard protection cover for Eachine E010, JJRC H36 or FuriBee F36 Tiny Whoop mini drones" http://www.thingiverse.com/thing:1954514 (Dec 9, 2016).
I adapted that design creating a new one to mount the Eachine TX03 FPV (first person view) AIO (all in one) camera besides to protect its antenna when is installed for creating the named "Tiny Whoop" mini drone using the frames of the models Eachine E010, JJRC H36 or FuriBee F36, that do not come with FPV camera.
As the previous design I combined the mounts and guards creating 18 different kits / files ready for print. If you prefer you can also download the parts separately.
Before inserting the camera into the mount, is possible that you need to cut a bit the black glue protection of the power wires (red and black) where they are soldered to the board, because they might have a vertical orientation that would difficult the correct insertion. With my TX03, I removed a bit this black glue protection and the wires are free to enter perfectly in the space for them of the mount.
To insert the camera into the mount, please insert firstly the left side rotating the camera and then the right side (with the lens camera in front of you), pressing down until camera touches the base. For accomplish this, you will require see the lower corners of the two electronic boards of the camera, moving and pressing the camera until fits correctly inside the space. When it touches the base it will fit perfectly and will not move. To extract it from the mount do it in reverse mode. You can bend the sides for ease the extraction.
For last, to get better result in the printing is mandatory to use a 0.4 mm nozzle or less in the 3D printer because the insertion guards holes have thin walls. All my printing tests were made using 0.4 mm nozzle and choosing 0.8 mm for shell thickness in Cura software slicer and a low printing speed.
This design is valid for Eachine TX03 FPV AIO mini cameras. However it is not valid for Eachine TX01 and Eachine TX02 FPV AIO cameras because they have different sizes compared to TX03. For TX01 and TX02 you can download a different mount desinged by me from Thingiverse: http://www.thingiverse.com/thing:1954514
Due to the increase of the total weight of the drone using the Eachine TX03 camera with this mount I recommend to replace the factory motors with others with more power, like Chaoli 615.
The files available to download are:
Mount parts (double or single protection):
Guards / hooks parts (bent and straight versions):
- bent-large-2.4-tiny-whoop-eachine-tx03-antenna-guard-sepela-sxs.stl (original design by "sepela")
- bent-large-2.0-tiny-whoop-eachine-tx03-antenna-guard-diymik-sxs.stl (original design by "diymik")
Spacers (original design by "Diymik")