One picture shows how the finished version should be.
I just created them to be printed without support. You will need a heat-blower to form them.
I used 3mm LED's for the eyes. The Eyes are printed Transparent and with 100% infill. The connector pins are simple microelectronic pins, which are normally used for arduinos or something similar. I took 12V voltage supply, but just because I got a 12V power pack.
I made 2 just to be printed. ist "part01-11" and "part12-17". You will also Need part 18 and the Stand, but I thought it would be easier to print These parts together. You will also Need to mirror all parts (1-18) one time, toget a full faceplate
What you need for the whole mask:
1xM4 screw with nut.
4x connector Pins (2x male, 2x female)
8x 3mm led
resistor, depending on your supply voltage
Some black cloth or foam for the backround
Some old electronicparts to look cool down below in the center :-)
some lether (for the brown parts)
I am not ready with my paint Job. The Surface was sanded by a friend - Sven S. - thanks for that.
Hope you enjoy it. If you got any questions, feel free to ask.
More from Sculptures
Save to Dropbox
If you’re logged into Dropbox, you can save directly to Dropbox.
Show Some Love
Say thanks by giving DaDave a tip and help them continue to share amazing Things with
the Thingiverse community.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.