GotWay Msuper V3 is an Electric Unicycle with an open wheel design. Consequently, when it gets wet and dirty, it throws everything at your back the road has to offer.
This mudguard is ready for use straight from the printer. Snap it to the rear wheel opening of your Msuper's shell and you're good to go. The outward pressure of the lower clamps will keep it in place until you remove it just as easily.
Edit: someone from California just mentioned, it could be smarter to use ABS instead of PLA for temperature stability. If you're living in warmer areas, I suggest following that advice (needs a heated print bed).
Update Feb 15, 2017: Just uploaded the "Klingon Edition" to address concerns, the mudguard could slide down eventually. Tested successfully on my wheel today and will be tested by others shortly. I suggest to use this one instead.
Update Jul 24, 2017: Added a mudguard version for mounting a German insurance plate. Don't use this unless you absolutely have to! And please add a standard plastic plate holder to cover the sharp edges.
Place upright on print bed with lower edge flat on the ground (so it points upward slightly diagonally). That way it does not need supports, but a brim can help with platform adhesion.
Position on print bed
See a real life test: https://youtu.be/uMWm5L3I1fM
When it comes to 3D modeling, I have no idea, what I'm doing! In fact, this is my very first design.
While I certainly don't want to harm anybody, I cannot guarantee or accept liability for any aspect of this design. It may not fit your wheel, or worst case come off during your ride, block your wheel and break your neck. If you do use my file, you will do so entirely at your own risk!
Made one? Please put your experiences in the comments.