Eventually a full set of costume Storm Trooper armour. Scale parts as needed for size of person.
Part one (a and b) Spats.
Made in eSun PLA+ (or similar, PETG might work very well, but its 30% higher cost) for best finish. (eSun ABS+ tends to have poor layer bonding but glues better).
mk7 is a one piece spat to save gluing the bits together. (yes its a mk7, this is primarily an exercise in learning Fusion360).
Shin, left hand. still being worked on. Uplaoded as a sliced ALPHA part. Please note this is not finished, I just sliced it into 3 parts to suit a 170mm Z 3D printer as an experiment. Should print fine on 200x200x170mm printers.
Shin, right hand. BETA, ie not yet printed, it is nearly 400mm high so you will need a Creality CR10S or similar.
Parts made in white eSun PLA+
Designed in Fusion 360