A front panel for the Tevo Black Widow printer for mounting the MKS TFT32 controller.
Print the panel, case and 4 spacers.
Should not need supports, I printed mine without.
Requires 4 M3 X 25 screw and nuts.
Put the controller into case, then place the 4 M3 screws through the holes then put the spacers on the screws and mount it on the new front panel.
Plug in the cable and power on, if its not controlling the printer check the baud rate in the settings is the same as the printers.
Note - Unplug the display when upgrading firmware
SD card is easier to access
Supports SD & USB printing
Supports WIfi module
Much easier to navigate the menus
Supports filament run out detection
Plug & play, no programming required
The screens can be customized,.
Not all info is shown on the printing screen. (Doesn't show X,Y & Z positions)