Print and play pieces for Santorini. I created these from scratch based on the kickstarter to go with the rest of the print and play cards and board. I took these pieces a step further and created variations of the lvl1 and 2 blocks for a total of 8 different styles of pieces. Fantastic game, lots of fun. I'm currently just using Marvin's for game pieces, the default size is perfect!
Suggest you check it out - https://www.kickstarter.com/projects/roxley/santorini-learn-it-in-30-seconds-play-it-for-life
If there is interest in this I plan on expanding this further with custom pieces and a custom 3d board.
You can feel free to change the resolution up, but with .2mm layer height total print time was nearly 30 hours for me (I go pretty slow).
For full piece set
Print 7 of each lvl1 variation
Print 6 of each lvl 2 variation
Print 12 Lvl 3 pieces
Print 16 Domes
Supports - Depending on your printer, Lvl1 you don't need any supports. All the other blocks will need a little support around the base to make the lip clean so they fit together. If you can't print the roof without supports you may need it on all of them, I'd suggest calibrating your printer better to allow for better bridging though.
As far as infill goes you shouldn't need much, but its your choice.