This is a remix of a previous delta effector I had been using from the awesome work on Duet and auto-calibration that DC42 has done for delta printers.
There are 2 versions of this design:
1.threaded inserts for using M3 machine screws(links below)
2.plastic screws for fasteners
Mount for Mini differential IR sensor for auto-calibration of delta printers
Mount for 2x 40mm part cooling fans
Mount for E3D Heatsink 40mm cooilng fan
Brass threaded inserts so threads dont wear out and fasteners can be tightly fastened
What you need to build this design:
Various M3 SHCS or other type of machine screws for the threaded inserts
Plastic screws which can be found in inkjet printers and other hardware
3x 40mm cooling fans(I had good expirence with these 3d fans but not the 30mm ones)
Threaded Inserts(if needed) can be found here:
(install with a soldering iron)(be careful not to burn yourself.)
E3d v6 heatsink silicone sock(very very stable hotend temperature performace)
note:should recalibrate the PID values in your heater control loop when installing the silicone heater sock.
PLA or ABS
use the correct amount of Infill overlap/backslash compensation to make sure to get a strong part out of your printer.
May cause some slicers to hicciup due to the large file size. It'll work eventually.
Lots of experience in Solidworks 2016