I present my very own Pan Tilt module designed around cheap 9 gram metal gear servos for the Mobius and RunCam HD/ HD 2 action cameras. I tried many of the pan tilts here on thingiverse and always had some things that I didn't like about the design so decided to make my own.
The design is super simple and very robust. I'll post some flying video the next chance i get to take it up.
Print settings I used.
.2 mm Layer Height
30% infill - honeycomb
No Supports needed
I tried to keep tolerances loose but not too loose. I had to take a file to a few of the holes to get them to fit.
Servos I'm using...
TGY-R5180MG - 180 degree pan servo. I used the wheel arm for added structural support.
TGY-50090M - Tilt servo.
I use velcro to hold the camera to the top plate and so far it seems more than adequate.
I have also included the inventor files in case you want to use different servos and need to move holes/ spacing around.
Would love to have suggestions to make it better.