This is a minorly amended version RedbeardPete's EFX Prop Spinner, specifically:
- Simplified the base to remove skirt (which required a lot of support material), and to fill in the cutout area where the cone originally sat
- Removed the bottom edge of the cone which would normally sit in the base's cut-out. Now the pieces just sit flat instead. Simplifies printability further, and increases rigidity of the base (the two screw fixtures will be sufficient to hold the pieces in alignment).
- Increased prop hole to take a 9" Prop.
These changes mean I can use it to replace my Hyperbipe spinner (the stock one is foam, and comes off almost immediately), and print with a lot less post-processing.
Ebay Chinese CTC i3 clone
Opted for ABS in 0.1mm, 40% cubic infill; for best quality, layer adhesion and strength. Will look to acetone-vapor-bath the final produce to further bind the layers and provide a shiny finish.
Printed with a 10mm brim (overkill) to stop warping/delamination whilst printing and cooling. Wait until part is at room temperature before attempting to remove from the print bed so it doesn't warp post-removal (for ABS at least).