I tried to fix the following problems in the original design:
The X axis can be pushed up and down, which can be problematic especially for auto bed leveling with constant z motion. This is due to the flexible coupler and the bending of the acrylic mount of the Z motor. This design inverts the placement of the motor, which allows the lead screw to sit directly on the motor shaft inside the coupler. This completely prevents any downward push and get rid of the top acrylic bending problem.
Both rods are locked in place with pillow block bearings, which prevent the x axis from rotating like in the original single rod setup. I prefer the single motor solution because the two rods are always in-sync and I can manually turn the z motor without resyncing.
An adjustable z axis limit for quick fine-tuning the height.
Both rods are positioned much closer to the X axis (Photo 4) to reduce the bending torque exerted on the top rod mount (or the original acrylic motor mount). And the top rod mounts are reinforced so that there is minimal or no bending.
The nut mount design allows the x axis to rigidly sit directly on the brass nut of the lead screw to prevent any bending torque and vibration (Photo 4). Both 4 and 5 help prevent banding.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.