Laser Cutter (FullSpectrum, 45W)
I cut this on 3mm Acrylic using a Laser Cutter.
The yellow and red lines are for alignment and instructions only (do not cut); black and green lines are for engraving, while blue lines are for cutting.
Glue the walls to the holes of the base, having the engraved texts and images facing upwards. Actually, a press-fit would be enough, but I prefer to add some transparent glue to increase rigidity and stability.
Finally, the Semi-Circles should be stacked (and glued) on top of each other to reach a height of 15 mm (for the poker chips), i.e.:
4x (3 pcs) = 12 pcs on 5mm acrylic
4x (5 pcs) = 20 pcs on 3mm acrylic