If you're using Cura you might have some troubles with supports since there's a raised edge at the top and bottom of the bearing holder. I had to go in and create my own supports in order for it to print correctly.
PS: Use a lighter and heat up the hex nut holes slightly to get a perfect fit!
We're sure MisterFresh would love to see what you've printed.
Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click
Post a Make to start uploading your photo. It’s even easier
to post a Make via the Thingiverse Mobile app (available via
and Apple App Store).