A standalone version of the center piece of the Joycon Grip. I made this to test out the rails for future designs. A few things to note:
The Joycons do NOT lock into the rails. However, friction seems to hold them in place quite well.
- There are supports in place for a small overhang near the top of each rail. Not sure if they work too well, but remember to cut them off once the print finishes.
I claim no responsibility if you screw up your Joycons with this print. So far, mine have seen no issues.
You'll need to cut off the overhang supports near the tops of the rails. After that, the Joycons should be able to just slide right in.