Like in the source project, there is multiple parts for this item : stand, hat, board side and cam side.
The stand is the same as the remixed project from andyleer.
I added plots (screw holes) to stick pizero board and camera in place.
I modified cam hole cause the original one didn't fit on my printed item.
I added a hat cause my printer sometime blend edges on little item.
I increased the thickness of both sides because they moved too much in the base.
Used with pizero v1.3 and pi cam rev 1.3.
Use of a cutter if an improvement in the printing surface has been chosen
I used SketchUp to design this.