Housing for a 600TVL CCTV/FPV camera from ebay/Banggood.
The OSD (MicroMinim-OSD) is also directly integrated into the housing.
It's intended to be mounted onto the Camera Plate of a ZMR250 with the Tilt-Mount but you can just break of the tabs of the Camera Housing and use it standalone.
There are three wires from the camera (Just cut the one for Audio). On the Micro-MinimOSD there is a row with Through-Holes. Route the Video-Wire through the DTR hole, 5V through 5V and GND through GND.
Solder the Video_Wire to Video-IN on the OSD. Cut the Power wires as close to the OSD-PCB as possible and solder them on. The rest of the connections should be clear.
To seal everything of just add a layer of Epoxy-Resin.
There are markings on the mounts every 15°.
To secure them to the Carbon-Plate just stick the small pins through the holes. Melt them and press them flat. Just like a Rivet