Loading
Incognito78

Anet A8 ultimate frame stabilizer (Crane edition)

by Incognito78 Mar 17, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

what are the support requirements? like touching bed? over a certain angle? this is where i always mess up thanks

Sorted out the scale setting in Cura 2.4. - What an idiot I am not to have seen this from the start!!

Printed the left and the right is about to start...

Thanks Incognito78

I think I must have done something wrong - after 8.75hours - the printed model was too short only around 220mm - also not wide enough to go across the motor mount backplate AND the slots are 6mm - acrylic frame is 8mm. Any ideas what went wrong?

Hi.
I think you let the slicer resize the model. I just made some screenshot how should be :)

Its a case of ...ooooppps ! Bit new to this and using ropes and climbing boots to get up the learning curve! Thanks for the info... and yes... I assumed what I saw was what was " the file to use as it is".