SuperNova inspired by rcFoamFighters SuperNova foam pusher plane.
Wings are 1 layer shells (0.4mm) with 1 layer cross internal structure (0.4mm).
3D files are of the right side of the plane only. You will need to mirror all the parts to make the left side.
Files with names starting with "smaller" is alternative prints for those who got smaller printers (split in 2 at center compared to the larger parts).
Center of gravity: approx 45,5 cm from the tip of the nose.
I got my plane to 1420 grams incl. electronics (4S 1300mAh).
Parts glue toghether using (sandpaper+) superglue.
My setup in the video:
Turnigy 60A speed controller
Turnigy 2836-2350 motor
7x5 propeller? (a bit uncertain)
4S 1300mAh battery
Modified RepRap Mendelmax
I made a couple of test prints on the pusher plate. When pusher plate was successful, I printed all the other files with success.