Loading
donnyb99

CR-10 50mm Fang Fan Mount/Duct/Shroud

by donnyb99 Mar 23, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

The fans are 50x50x10mm?

great work cobber just a note to thank you for your efforts. i made the remix with the 40mm stock hot end fan for a bit better visibility but it's all working great. Thanks again.

Thanks for the hard work mate I made a remix with the stock 40mm fan. The main reason i did this was for visability extra cooling ability is a bonus. viability is ACE !

I guess he means this one:
https://www.thingiverse.com/make:344247

Creality CR-10 40mm Hot end fan w/50mm part cooler

Any recommended fan speeds with this setup?

hey boss, for the cold end, how does the air exit? I am looking to make the cold side air flow move away from the print bed as it causing issues with ABS... =/

flip your fan 180° to reverse it's air flow

depending on how it exit the other side is what i am talking about. any wind inside the chamber and abs wants to run away and cry...So just flipping over the fan would send the air flow right to the bottom side of the other cooler and be pushed back down.