Loading
SavageRodent

SD Card Spinneroo

by SavageRodent Mar 29, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

This looks fantastic. Any chance of extending the ramp a little more toward the center of where the SD would be? I am doing an experiment with the size at 53% for micro SD cards. 53% is just big enough that the walls will be .04mm :). Based on my experiment stopping the pirnt just to see if things will fit ok, It looks like there will be a problem where the SD card will just have enough room that the edge of the micro SD cards can slide off one of the ramps. I am sure it will be quite weak and the micro SD card will likely get hung up on the stair stepping in the ramp even with me printing at 0.1mm layer height but I plan to combat the stair stepping by sanding the ramp so that it is smooth.

if you could make it customisable and set a number of sd cards. 20 sd cards is too many.

I agree 20 is a lot. But reducing the number of cards dosnt mean the thing can be much smaller and there seemed little point in reducing capacity just for the sake of it.

I agree, this is really nice design. But I would not like to have some SD cards out. I would only fill half of it, and rotate so that all are inside. Also if I turn it over they would all fall out, so I would also make a cover for it.

Exactly, a transparent cover for example, would be perfect for the project, but anyway it's a great idea. Congratulations to the author.

Yes, a cover would be a good idea.

The only concern with this I might have with this is abrasion. This is a really creative print. I can imagine using thsi if I had that many SD cards.