This is a custom joycon comfort grip for the Nintendo Switch. The original idea of this design is that the joycon rails would be tilted outward by 20 degrees to make the overall controller layout more similar to a standard controller. It's been separated out into 3 pieces to make printing/finishing easier, and also to make it more customizable with different pieces.
I've updated the rails to be a bit more accurate. The connection between the pieces has also been reworked, and I've added a smaller crest size so that tighter configurations can be used. I've also made more variants for the rail piece to highlight the customizability of this design. There is now a version with rails at twenty degrees, one at ten degrees, the default zero degree, a negative ten degrees, and a negative twenty degree piece. The grip it's self has also been updated to be more sturdy, and sit a bit more evenly when you put it down. It's fully compatible with all the afore mentioned rail parts. However, not all combinations have been tested for comfort yet. There will be more handle versions in the future to deal with this. These are not compatible with the earlier prototype versions
Eventually, I want this to grow into a wide variety of pieces that can be easily interchangeable, so people will be able to make the perfect joycon grip to fit their own personal comfort, and style preferences. I encourage everyone to remix this with their own pieces, or comment with suggestions or ideas you would like to see with this.
You will need at least one rail piece, one grip piece, and one crest piece. Print all pieces standing upright, as they have been uploaded, for better strength and to keep the docking rails and grip smooth.
Be sure to sand the rails where they contact the joycons for a better fit. sanding the rest for smoothness, and paint if you want to. It's not necessary, but this can give it a more polished look. If you paint the rail section, be sure to mask of the sides where the Joycons slide in and out, to prevent paint rub off and added thickness. I'd also recommend using spray on rubber on the grip to give it a better texture to hold on to.
This is designed to be held together with two m3 0.5 nuts, and two m3 0.5 screws 13-16 mm long. However, it can also be glued together or printed as one piece with just a little tweaking to the files.
Insert two M3 0.5 nuts into the slots on the crest piece, and line them up with the holes on the back.
Fit the crest and the grip into the slot on the rail section.
Insert two M3 0.5 screws into the holes on the back, and screw them into place.