I love the hitch design by fwillburn but was bothered by the fact it did not properly cover the hitch. This remix includes a 5mm wall after the logo closing the hitch mount.
The disadvantage of this design is a single color will wash out the logo. Therefore it is preferred to print in two colors. The logo ends exactly 10mm. The wall begins at that point. So you can change filament at 10 mm as shown in my pictures.
The design contains the square of the hitch mount embedded into the logo. Therefore, swapping out the color at the end of the logo print causes the square to be printed in the same color. Not a big deal but not perfect (see my pictures). An alternative is to print 5mm then swap. So the back of the log is the same color as the hitch mount.
I created a 3D printable hitch pin to attach the Jeep Hitch Cover to the vehicle. Check it out:
You can print this as two parts. The logo is exactly 10mm.