Simple case for FlySky's new radio receiver! (I printed in clear PLA)
It prints in two parts, and screws together using 2mm tapping screws.
I used 11mm length screws.
Takes about 25 minutes at .2mm resolution
Here's a 100 pack of 2mm screws on Amazon with prime shipping, if you need them ^-^
==Things to do==
-Make different versions for "only" PWM, i-bus, or PPM. As well as versions for each that cover the VBat plug, in case somebody wants that for some reason.
-Thicken the bottom half so the screws don't poke through
50% with triangular shaped. Though anything should work really.
Printed at 50mm/s speed, though 80 worked fine on my test versions
(I made 6 revisions before uploading! xD)