Grip for Sony Rx100 compact camera.
Glue to camera with 0.25 mm thick 3M VHB double sided tape F9473PC.
The model should be printed upright for best result.
The built-in support on the back is very easy to break off after printing.
It prints without further supports, if the layer heights are as described in printer settings.
If printed with larger layer height external support is needed.
It is recommended to print more than one model at a time to allow the plastic to cool down between layers.
Fillamentum ABS Extrafill Traffic Black
Extruder temperature 235 °C.
Bed temperature 110 °C.
15% fan speed.
Extrusion width 0.4 mm.
First layer height 0.2 mm.
0->2mm: Layer height 0.05 mm.
2mm ->: Layer height 0.1 mm.
50% rectilinear infill -45/45.