Here are the final parts for the chopper. Oil tank, oil cap, Callipers L & R front and one rear and the Carbi cover.
All parts are printed to 1.5 the size of the stl's. Everything was printed at 15% fill except the oil cap I did a 99%.
The oil tank I needed to trim a bit to make it fit. Just where it contacts the frame.
The Carbi cover I as had to trim some off it to allow it to slot in better.
The front callipers have to be glued on, all that is needed is a drop of super glue. Other than that everything should just slot in.
Hope you enjoy the Chopper. If you have any questions just ask. If you think any of the parts need changing let me know.
All the parts to build the whole bike are over the five sections of Motorbike fun design.
I am making a new part for the back guard at the moment as I dropped the chopper when I was fitting the oil tank, breaking back of the guard. I will try and scab a part on to it rather than printing a whole new rear section. That is why I haven't put a up a picture showing the hole bike. Once I do I will.
please let me know if you make one
EDITTED- Not too happy with the modified back but its done. I think I have spend close to 80+ hours on this. I though it would take some time but not this much.