Loading
Jstander

The Stash

by Jstander Apr 21, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

This is swaggy as hell! Super cool;-)

great design!

but because of the orientation, is the clip really strong enough?
also lots of support needed...
have you considered using a hole to put in on the button of your shirt?
just like this one here: http://www.thingiverse.com/thing:256061

Classy Bowtie

Also thank you for the compliment!

So i started out with the slide on button. I didnt like it, mainly i like a smaller center tie. It would pop off. Took me a bit but this clip is awesome if you take care of it. Only issue i had was sitting down on a tie and it snapping. You need the support if you print it as is. If you take off the clip, then no.

thx for the respond.
i think i'll give it a try as it is (no redesign).
but i already looked at the file and meshmixer found some issues. i'm going to upload a repaired remix next week or so.

for print settings, i think i'll go with 5-7perimeter for the clip and standard 3perimeter for the tie.
that should be way sufficient.