Once I decided that I was going to drive my new Wanhao D7 using a Raspberry Pi running NanoDLP it was time to start thinking about how to keep things neat and tidy. This is version one of that effort. It is probably going to stay version 1 for a while as I finally have resin arriving tomorrow!
This thing is now really two things. Since my workspace is far from level I decided that I needed adjustable feet. When I did that it was noticeable that there was room under the printer for the Raspberry Pi. Hence this new thing. I have kept the RPi mounted "bare" on the base as an aid to cooling it. Note that the photo shows the RPi in the center when the STL shows it to the side. The side is better for running of the video cable.
The original thing was built around the Raspberry Pi case by 0110-MP that you can find here: http://www.thingiverse.com/thing:922740.
One last update! This thing is now three things. In this latest variant I moved the RPi to the front and added some space to tie down cables. There is also a special joiner that fits on one side where the other would have been blocked. You will see what I mean.
Hardware required: M6 Bolts and Nuts. Lengths of 20-25 or even 30mm will work. Ideally a half nut to use as the brake. Also ideally a hex head bolt though you can use a nut as shown on a round head bolt.
I used a 600 micron nozzle to speed things up.
It only fits together one way. The fit of the tower into the stand should be tight. For max neatness you need a 12 inch HDMI cable and a 8-12 inch USB cable.