A simple, secure, robust, sturdy and customizable mount for a FatShark 600TVL FPV Tuned CMOS CCD FPV Camera for my MultiRotor H Body Modular System, http://www.thingiverse.com/thing:190912
Mount has slight degree of down deflection for the CCD, in which you can easily reduce downward angle by use of simple hobby file.
Future revisions, code will allow easier adjustment
This mount is used for the 15.5mm square tube designs, however is fully customizable via the OpenSCAD source, so you can easily adjust and modify to your specific needs.
Added Helper disk and slide in camera retainer.
The slide in camera retainer, is offset by 1mm to allow for variances in the TVL600 CCD housings.
Recommend 2 shells, 20% infill for this at .2 layer height.
No supports are needed.
Print time: ~35 mins.
Single STL file will print the mount, the slid in retainer and helper disk, which is easily snaps off for clean lines.