This salt cellar was inspired by Alton Brown's flip top variety made famous from the Good Eats television series. I just recently downloaded Fusion 360 and I wanted something relatively easy for my first project.
There are two versions of the base available; one with the glass attached (for single piece prints) and a version where they're separate.
The volume of the cellar is roughly 240 cm^2. I tested it with sugar and it would hold about 150g.
I printed the lid and the bowl at 7% infill but opted to use 7% on the bottom 5mm of the base and 100% past that for stability and strength.
This is my first design using Fusion 360!