I have make a full instruction for the build. From the Printing Parts over the equipment, the things you need to buy and the first test flight! And yes, it can fly very well!
You can find it here:
12x SPAX 2x10mm
24x SPAX 3x10mm
4x Motor 2205 (2204 is possible, too)
4x ESC without BEC and with min. 20A, better 30A
1x PDB with BEC
1x Flight Controler F3C
1x 4S LiPo Battery
Signal Cable in Black, Red and White
Cable for the Battery and PDB in Black and Red
But you will find a complete List with examples, instructions and the shops you can find all things you need for free here:
I printed the original TieFighter with the originals .STLs. But I found a lot of Problems and remixed a lot of the .STLs.
A few of the Inlets would not the right size, so I change it.
I sliced this from 2 to 4 Parts with enouth Space for glue.
Motor holder: (Tie Fighter 250er Quad Arm 2204-2205)
I make the hole bigger for the Engine, so the motor can run free.
Motor Mount: (Tie Fighter 250er Quad Motor Mount)
I make a Mount, that you can put betwen the motor and the holder.
LED: (Tie Fighter 250er Quad LED Front)
For the Front Windows I designet a LED Light separation.
Top and Button Cover:
I designet 2 Cover, for the Top and Downside of the main Body. The originial showed a cross, but you never find that in the comics or movies, so I designet it like in "A new Hope".
You can find all .STLs you need at this Remix. So the problem is, that the Engineer from the original Data doesn´t answered on this or other platforms. So you cant find the help from him.
If you need help with this build, pls look at the instruction you can find here: http://www.kopterforum.de/topic/68136-star-wars-tie-fighter-250er-quad-racer/