A phone stand with adjustable angle that folds flat for easy travelling. Should fit most phones, Designed for a Galaxy Edge 6+.
Snaps together and angle adjusts like the classic reclining pool chair back. The only post printing work I did was to file the corner round on the main hinge at the front so there is slightly more clearance for my case. Maybe someday I'll round the corner on the model, but its pretty quick and easy to do with a file or dremel. Works fine as is though. Gives a good range of adjustment from laid back to almost upright. The pictures are a little odd, but its tough to photograph the phone when its in the stand so I used a hard drive platter as a mirror. This thing works great in portrait or landscape mode. I might add some stick on rubber feet so it doesn't slide around so easily, but I'm pleased with the way it turned out. May it serve you well. Interesting note: The stander piece printed hollow in spite of having 50% infill selected, but it still turned out fine. I used 3 perimeters and 3 top and bottom layers. It took just over 2 hours to print all 3 parts on a Rostock Max v3 at 60mm/sec, Purple Inland PLA 218 nozzle-35 bed, fans at 50%