A little choppy on the upper cell cradle but at least we have an A sled in the open source community now. You need to have your strength game on point for this one. I personally use 2mm shell thickness for sleds, and 80% infill. A bit of epoxy to reinforce the spring clips won't hurt either. These hold up with my settings using Hatchbox PLA, if you have problems just let me know in the comments. Remixes are fully welcomed.
Takes the 204/208 keystone clips. Can be resized a few mm's in slicer to accommodate for a hammond A without any issues.
Email [email protected] for custom designs
We do still produce boxes but it's wholesale only and reserved mostly for shops.
supports touching build plate, an extra 4 mins in print time with supports. Total print time for me was 45 mins (a little slow for better resolution, i'm in no rush during this lifetime)