Made this mount for my Anet A6. You can choose how many you print and where they go, but I use 4 and it is plenty. Has countersunk holes for screws to secure it to the surface. May need to bore out the hole for the threaded rod due to drooping while printing.
Tip: Use a ruler/straight edge to align the mounts
There are 2 versions:
Version 1: Better to use pre-assembly for you will need to take the y-axis apart to put on.
This version is more difficult to install but is more secure (in my opinion)
Took me less than 5 minutes to get them all on and secure
Version 2: Made for post assembly and just slip over the threaded rod and can be fastened.
This version is much easier to install.
Print desired amount all at once.