Troubles with printing the threaded rods?
This is a low overhang design which was also used for the G-Clamp. http://www.thingiverse.com/thing:1673030
Print single rods and plug them into the sliding jaw or use the
combined version. The new main gears are required as well.
We're sure johann517 would love to see what you've printed.
Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click
Post a Make to start uploading your photo. It’s even easier
to post a Make via the Thingiverse Mobile app (available via
and Apple App Store).