A case for a raspberry pi with a cheap ebay 5 inch HDMI tft/lcd touch screen (see pictures).
I could not find a case that hides the ugly silver frame around the screen, so I made my own.
It has very sharp edges/corners, but it's good enough for me.
The stupid hdmi connector fits inside the "tower" on top. Held together with 4 short M3 screws. 3 of the standoffs included with the screen must be mounted in the corners to keep the screen pushed against the bezel. (You can see one of them in the picture of the back cover).
Holes on the back for accessing the SD card and the useless "backlight switch".
My first attempt at an scad model, and I stopped writing as soon as I had a case that worked for me, so don't kill me if the code is crap. I know it is.
The print is not very good, I'm sure you can do better. I printed it on a geetech i3 clone at too high speed, no supports, no brim, very variable temperature.