Direct replacement gimbal rims for the FrSky Taranis QX7. There is nothing wrong with the original ones, but I felt like pimping my transmitter with yellow accents so I designed these. Very nice fit with the given print settings.
Install is very easy:
- Remove 4 screws holding the back cover in place.
- Remove 4 screws holding the gimbal in place.
- Replace the rim.
- Screw everything back in place.
Time to give your Taranis a new look with your favorite filament?
Also check out my other QX7 mods:
External module bay cover: http://www.thingiverse.com/thing:2265682
1.5/3mm stick extenders: http://www.thingiverse.com/thing:2265690
I used 0.12mm layer thickness. Use low perimeter speeds to get clean overhang in the sloped part. I used 30mm/s for perimeters and 50mm/s for anything else, printed very nicely.