Using the Rotor Riot logo to protect your FS-i6 sticks
Inspired from http://www.thingiverse.com/thing:2073993
but redrawn from scratch, using logo and joined together with a bridge as I prefer those style designs.
It should protect the controller sticks when they are in a case from being knocked.
Note: I had to angle the model diagonally on my smaller print bed to make it fit.
This design may not be used for commercial gain due to the source logo being used under those restrictions.
2017 June - Added version that wraps the lanyard anchor point. By clipping the lanyard in after the protector, the protector will be held in place better. Also is tight fit so friction should even keep it in place without clip in gentle use.
V3 has slightly better fit by going a few more mm into the recesses for the sticks.
V5 has wrap around for the lanyard fixing with a friction fit to keep in in place
With another colour change look how good it looks with this "make"! https://www.thingiverse.com/make:591920
You can pause the print at layer after the background infill has finished an print the skull in another colour for more impact.