(Printing in progress) More picture later
This is a case for my small o'scope, very tiny to stay in backpack. (I am a customer service engineer never in compagny's office.)
What you need :
- 1 x Raspberry PI Compatible with Biscope probe.
- 1 x Bitscope BS05U
- 1 x Bitscope Hammerhead
- 1 x Official Raspberry 7" touch screen
- 1 x KCD1-104 power switch
- 1 x Usb female plug 180°
- 1 x 8Go SD card
- 1 x USB battery bank or Usb Supply
- 4 x M3x20mm
- a lot of patience for an 11Hrs print!!
To reduce the volume of this o'scope I turned Upside Down the raspberry PI. (And gently twisted the video ribbon cable.)
Prusa I3 from Emotion-tech
I used brim and supports.