An 8-slot case for Nintendo DS Game cartridges. This case:
Works with both 3DS and NDS carts
Displays game art
Allows carts to sit flush in the case, protecting them on all sides
Not much more to say. The scad file (which is very poorly written) is available if you need to tweak any tolerances.
.3 mm tip size, .2 mm layer height
Use X/Y expansion settings in your slicer of choice for quick tolerance adjustment.
Bridging works well on any calibrated printer.
After printing, a light sanding is recommended. Try to avoid removing too much material from the cartridge slots.
If printed in ABS, it is not recommended that you smooth the surface with acetone, as it may mess with slot tolerances and spacing.
If the slots are too large, it is recommended that you place a slip Gaffer tape in the slot, as it helps push up against the cartridge.