This is a mount for a mobius mini. It can also provide room to mount an Eachine ET200 VTX for FPV.
The camera is mounted upside down with the cooling/.25" mount installed. This way the camera can get rid of excess heat. You can configure the camera in mSetup to rotate the recording 180 degrees to compensate.
It is preferable to print this mount in flexible plastic for dampening and to be able to slide the camera in and out easily.
I have not managed to lose the camera while inside the full cover mount yet so it seems to be working.
The OpenSCAD sources are provided and there are some parameters which can be adjusted such as angle and height.
There are a few different variations provided: a 20 degree mount, a 15 degree one and a 20 degree without top cover. This one is about 4 grams lighter than the other two.
Print this mount using flexible material such as TPU (ninjaflex).
To avoid excess support structures print the mount on its tail, meaning the opening to slide int the camera is on the print bed. In Slic3r rotate -90 degrees along the Y-axis.