Semi-Circular Anet A8 Fan Duct for Don1337's carriage

by Murkser May 15, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

This was much closer than others I printed & tried. However, I had to sand the outer edges (the longer sides) & squeeze it with some channel locks to slightly bend it inward to get it to fit my fan. I may have printed it with the wrong settings making it a little too big. But after a little elbow grease, it fit & I know it's not going to fall out like the one that came with the ANET A8. Great job & Thanks Murkser!!

I had to sand mine as well. I used Cura with the prusa3 to convert to gcode. is that what you use? I read an article on how to custom setup a printer. wondering if i should try that instead.

hi i need to retract my comment...it does fit...my printer just wasnt aligned correctly....it actually works great...thank you

Comments deleted.