Gimbal protectors for the FrSky Taranis QX7. For some reason, the left stick is 0.2mm thicker than the right one (and I'm even not the only one to report this). I included one .stl file for both sticks, so be sure to print one of each type. For me, 8.20mm and 8.40mm were nice and tight fit. However, your mileage may vary depending on printer/print settings etc. If they are not a perfect fit, scaling them in slicer by 1-3% should do the trick.
The overhangs in the bottom parts are quite severe. If using PLA, use proper cooling / low printing speeds / ( even supports) to prevent them drooping. I used PLA with 20mm/s for perimeters and 30mm/s for infill and no supports. Printed pretty well. If possible, mess with line width in slicer to get best fill pattern for bottom and top layers.