UPDATE: edited Part A and B to leave more room for the bearings, so they don't rub.
A screw controled tightening system for the Tronxy X1's sometimes wobbly y-bed.
I did previously use the model from PB2000 https://www.thingiverse.com/thing:2203872 , but either i was doing something dumb, or my matrial wasn't good enough; the bed started wobbling again after a couple prints.
Part C and D are optional and made to fit the spare M5 screw i had leftover. Required is a M5 Nut + a M5 screw with 25mm length (without part C+D) or 30mm length (with part C+D)
Suggestions or requests are welcome!
All parts have a 0.2mm tolerance modeled. If your printer requires more, print with enough shells/outer layers to file the parts down to fit.
Part D could use a higher print resolution in order to get a better fit of the tip.