Things you need for this print:
• Hotglue (Not for the v2 version)
• maximum 3m LED ribbon
• transparent PLA filament
• (additional) Wooden filament
0.4 nozzle and a layerhight of 0.3 and 0.2 at the base
Zero only 20% at the Base
Info for new v2 Version:
In the new version you have better files where the pit for the lampshade and the lightpillar is width enough. Also I add a additional base with bigger holes for the wiring.
Info for old Files:
In my print the pit at the base for the lampshade and the lightpillar unfortunately was to small. So I had to glue the things with hotglue togehter.
Also I had problems with the size of the conection plug of the LED ribbon. So I use some jumper wires for the connection.
This is my first selfmade design. Also it's my thirst experience with SketchUp.
I hope the design is not to bad for this. (V2 Version is made with Fusion 360)
The lampshade and the lightpillar is designed for vasemode (in cura called "spiralize outer contour") so you can print it faster.