Outdoor Wine Glass Holder

by geraldoramos May 30, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

You said M3 screws are needed. Any particular length? Where did you buy them? Do you have a part number?
I found these, but don't know if they will suffice: https://goo.gl/My9fuk

The holes they go in are 8mm deep

I would like to make this, but I'm not sure what you mean by it needs support material? Do I need to alter anything? I use a monoprice Ultimate (Wanhao D6) and I was thinking I could just load this into Cura and save the gcode to my SD card and print from that. I've done that with other prints, but I'm not sure how to add "support" material if it's said it's needed like you do here with this object.

Hi, Make sure you enable "Generate support" when slicing using Cura. Here is more information about support in general and what it does:

Here is where I believe you should mark "Generate Support":