Wahl Hair Clipper Attachments v2.0 W.I.P.
Added support to side walls that mate with Whal Clippers
Redesigned Clip Mechanism for increased strength
Increased print angle to reduce stringing and increase strength
EDIT 6/4/17: Raised font is now beveled to prevent interference with the bottom of the clippers. Cut two notched into the release pad to allow the pad to fully seat into clippers.
note: Work In Progress
May need to trim clip, I had to add 2 little supports otherwise the clip tab would print in mid air
Currently test printing & fitting, will make adjustments as needed
Recommended 80-100% infill
ABS would be best for this print, I wouldn't use PETG as it is too brittle
PLA will work as well but won't be quite as flexible (maybe print a few spares for the sizes you use most)