- edit july 6th: I printed one in ABS and it works great. the tolerances were a little tight, it didn't closed quite right, so all files have been edited accordingly. I haven't tested the new ones, but will soon. they would fit pretty good.
*new edit december 2018: seem my fies only had thalf the parts for each size, so I fixed that. hopefully no one had isues between whenever that happenned and now.
This is a fancy model of 8mm spark plug wire separator (as opposed to plain ones, which can be found here: https://www.thingiverse.com/thing:2374214).
It's fancy because there is a top and a bottom half, which fit within each other. Well printed, they should look like it's just one block. Also, there is no snapping/clipping mechanism; each half hold on to the wires, and that's what makes them hold together.
There are models for 2 wires, 3 wires, 4 wires, 5 wires and 6 wires. anything you want, it's there.
THIS NEEDS TO BE PRINTED IN ABS. I printed other wire separators in PLA, and an engine bay is simply too hot; the parts got soft and warped so that the wires came loose..
By the way, If you like it, dont' just add it to a collection, please LIKE IT... Same for if you make it; post a i made it!