I have my ANET A8 located in a case, and having the micro SD-CARD on the side makes it difficult to get to and their is always the fear of dropping the micro SD card on/into the logic board.
I used a standard micro SD card extension cable I bought from ebay (here:- http://www.ebay.co.uk/itm/231567666416?_trksid=p2057872.m2749.l2648&ssPageName=STRK%3AMEBIDX%3AIT ), then made a frame that just clips on to the ANET's horizontal frame (the part where the screen is located). The cable adaptor just presses in to it, then print and add the cover for a better look. No gluing required, it, it should all just snap together.
My printer coped with the bridging without using any support at all. Hopefully yours will be the same.
Removed a couple of strands because I didn't use supports, but little work required.
Onshape used, of course. Why use anything else!